SmartiPi Touch

Facebooktwittergoogle_plusredditpinterestlinkedinmail

I have been amongst the first people to believe that Tom Murray would have delivered a quality project in time and decided to found it almost immediately.

After finally having received two SmartiPi Touch enclosures, I have no troubles telling you that I am extremely happy with those.

The SmartiPi touch is a case and stand for the Official Raspberry Pi touch display. (display not included) The display is secured into the case with four screws. A Raspberry Pi 2, B+ or A+ is then enclosed in the compartment on the back of the case. A simple door covers the the Pi when it is in the compartment. The ribbon cable that comes with the display connects into the Raspberry Pi DSI port. The stand has a pivot that allows you to adjust the angle of the screen.

Have a look at my video below where I am going to tell you my impressions on the SmartiPi Touch whilst I am having a go at building it.

You can read much more on the kickstarter page for this project

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.